Skip to the content
Handiwork Haven

Starting and finishing a thread

How to set up your fabric and floss, start a thread so it can't pull out, and finish it neatly on the back.

Also called: Waste knot, Away knotLevel: Start here
firm asa drumscrew

Step 1 of 8

Loosen the hoop's screw, lay the fabric over the inner ring and press the outer ring on top. Smooth the fabric and tighten the screw until it's firm, like a drum.

If it goes wrong

The knot pulls through to the front
Use a waste knot or away knot instead, or make a double knot. On loose fabric, a plain knot will always slip through.
The floss tangles and knots itself
Separate the strands one at a time, and use a shorter length: no longer than your arm from fingertip to elbow, about 45 cm (18 in).
Dark threads show through on the front
Don't carry thread across the back between parts of the design. Finish off and start again in the new place.
The fabric goes slack while you stitch
Tighten the hoop screw again and pull the fabric smooth. Check it every so often.

Tips

  • Let the needle hang down now and then so the thread can untwist.
  • Take the fabric out of the hoop when you stop for the day, so the ring doesn't leave a mark.